Gillette Go
Razor Handle
Gillette RZRMKR Competition, 2016
The following project formed my entry for the Gillette RZRMKR competition, where I tried to reinvent the Gillette razor handle using 3D
printing.
I found that no high-end
shaving companies sell
highly portable
razor’s:
most are offered
by start-ups,
using poor
quality blades.
Instead, I started this design from
the best blades available, and
made a portable razor handle to accommodate them. This ensured portability, but
not at the expense of a clean shave.
![]()
The final design allows the
razor to be slid into the handle – acting as a container for
travel. It also
promotes a
more natural wiping motion for shaving, but can be held in other
orientations
to suit your shaving needs.
The design was awarded 3rd place, and the rights purchased
by
Gillette.
Riyadh Rateme 2018 — London, UK